Hi everyone, today I sharing a 3D Pop-Up Cube Card.
I made this straight after the other 3D Cube Block card I made as I had all the stuff out and ready.
I’ve made similar before, but this one is a little different.
If you would like to make the one above check out my tutorial here.
SUPPLIES USED TO MAKE THIS CARD
RSPB Tropical Birds paper pad is available here.
MEASUREMENTS NEEDED TO MAKE THIS CARD
1 piece of 6′ x 10.1/2 card for the main card.
Score along the 10.1/2 side at 2.1/2, 5′, 7.1/2 & 10′
Score along the 6′ side at 1/2′, 3′ & 5.1/2
1 piece of 5′ x 7′ card.
Score along the 5′ side at 2.1/2
2-4 pieces of 2.1/4 x 6.3/4 card and 2-4 pieces of 2′ x 6.1/2 pattern paper for the larger panels.
8 pieces of 2.1/2 x 2.1/2 card and 8 pieces of 2′ x 2′ pattern paper to cover the squares
1 piece of 1′ x 6′ acetate for the pop-up bit.
Score at 1/2′ & 5.1/2 along the 6′ side.
Check out my full tutorial below to see how I made it.
As always thank you for stopping by.
Disclaimer Some of the product links used are affiliated, these do not cost you extra but by using them I will receive a small % of the sales which then help me to continue bringing you great YouTube tutorials. Thank you all for your support.
You must be logged in to post a comment.